That one Tuesday where everything went sideways in my shop

Last week I had a job in Portland fitting uppers for a tiny galley kitchen, and the whole day was a comedy of errors. The laser measure gave me a reading that was 3 inches off, then I dropped my favorite chisel into the glue pot, and to top it off the client's cat sat on my cut list and smudged half the numbers. I ended up recutting the same door panel twice before I realized the wall wasn't plumb, which I should've checked at 8am instead of 2pm. Anyone else have a day where every tool seems to conspire against you, or was it just my lucky charm failing me that morning?

0 comments

0 Comments

No comments yet

Be the first to share your thoughts on this discussion.