Tried a heat gun on a stuck dryer drum bearing last Tuesday and it cost me two hours
I had a Whirlpool dryer with a drum that would not budge off the shaft, so I grabbed my heat gun and gave it about 90 seconds at 750 degrees. The bearing came loose, but the heat warped the plastic blower housing just enough that it rubbed the wheel and made a new noise. I spent two hours chasing a squeal that was not there when I started. So now I am stuck between two views. One side says heat is fine if you watch the clock and keep it off plastic, and the other side says pull the whole drum assembly and use a puller instead. I am leaning toward the puller after that mess. What do you all do on these rusted shafts, and is there a safe cutoff time with the heat gun?