That 2-block trick on the boom pins finally stopped my 30 minute greasing slog
Spent years dreading the greasing day on our Liebherr 130 ton because those boom pins were always a fight to get lube into. Last month a retired operator named Walt out of Corpus showed me to hit the zerks with the boom at about 45 degrees instead of laid flat, and the grease finally took without backing up on me. Cut the job down to like 12 minutes and I'm not busting knuckles on fittings no more. Also found out the pin at the base likes a little weight off it, so we chock it and barely touch the controls. Anybody else got a position trick for the tough fittings on the older rigs?